The Tone 2 delivers maximum grip with more edges for control. A 26mm ramped kick backs up powerful turns, and the 3-piece design fits a range of surfboards.
ArchPatternKick3-piece · Square in squareDetailsLess
Dimensions
Front widthNot listed
LengthNot listed
Tail widthNot listed
Profile
K-5 Curved ramp · 26 mm high over 68 mmA-21 arch
Kick18263026 mm
Arch057105 mm
Marks show where this grip sits across the FK range.
Best for
ShortboardsFits most shortboard tail shapes.
Grip & build
G-22 Square in squareStepped open squares. Maximum grip, thin underfoot.
Circle cut-outsExtra toe hold and quicker foot placement.
3-pieceArch bar plus two tail pieces. Fits a range of tail shapes.
About our traction
For 30 years FK Surf has been making surfboard traction using the same specialised team and the same specialised factory. Over time we have refined designs, materials, traction patterns and gluing processes to create a range of grips that's unrivalled on price, quality and design choices.
All of our tail pads feature our ultra lightweight, extra grippy EVA (ethylene-vinyl acetate) foam and are backed with the best gluing process in the business. The result is incredible individualised traction that will stand the test of time at a price that won't have you mortgaging your next surf trip.
Fitting your grip
1. Clean the board
Thoroughly clean all traces of wax, dirt and grit from the surfboard. DO NOT USE oil based cleaning products. We recommend acetone, then rinse with hot water.
2. Position and mark
Positioning your tail pad is probably your most important decision when it comes to board performance. It is essential it is positioned just in front of the leash plug, and ideally the base of the kick tail should be placed directly above the end of your back fin.
3. Apply the grip
Begin by lining up and marking the correct position for the rear of the kick. Peel off the backing sticker of the centre piece. Starting at the kick end, centre this piece and align it with your stringer as you work it forward and stick it down. From this initial piece, position the other pieces to suit the overall tail shape and positioning required. When you are happy with the look and position, firmly apply pressure to all of the grip, particularly the edges and kick area, to make sure everything is firmly down. Wait 24 hours for maximum bond. If there are air bubbles under the grip, insert a needle into the problem area and work them out using pressure.
Note: grips only come unstuck due to poor surface preparation. In such cases, restick the lifting area using contact adhesive.
Tone 2: more edges, more grip, more control.
FEATURES
Multi-layered square traction pattern: Delivers maximum grip with more edges for enhanced control.
Circle cut-outs: Provides secure toe hold for advanced manoeuvres.
26mm ramped kick tail: Offers firm back foot support for powerful turns.
5mm arch bar: Mid size arch with lots of edges.
3-piece design: Versatile design to fit a range of surfboards.
MORE
All of our tail pads feature our ultra lightweight, extra grippy EVA (ethylene-vinyl acetate) foam and are backed with the best gluing process in the business. The result of our development process is incredible individualised traction that will stand the test of time at a price that won't have you mortgaging your next surf trip.
