The Atomic pairs a multi-layered square with cross traction pattern with a thinner feel underfoot. A 30mm super kick set at 45° to vertical is made for aggressive manoeuvres, and the 10mm arch adds more edges.
K-14 Super kick · 30 mm high over 65 mmA-22 arch · Circular cut-outs
Kick18263030 mm
Arch0571010 mm
Marks show where this grip sits across the FK range.
Best for
Airs and big turnsHigh kick for leverage on airs and hard turns.
ShortboardsFits most shortboard tail shapes.
Grip & build
G-3 Bevelled square with cross on topRaised squares with bevelled sides. Grip in every direction.
Circle cut-outsExtra toe hold and quicker foot placement.
Linear cut-outsSlots add edges for toe hold.
3-pieceArch bar plus two tail pieces. Fits a range of tail shapes.
About our traction
For 30 years FK Surf has been making surfboard traction using the same specialised team and the same specialised factory. Over time we have refined designs, materials, traction patterns and gluing processes to create a range of grips that's unrivalled on price, quality and design choices.
All of our tail pads feature our ultra lightweight, extra grippy EVA (ethylene-vinyl acetate) foam and are backed with the best gluing process in the business. The result is incredible individualised traction that will stand the test of time at a price that won't have you mortgaging your next surf trip.
Fitting your grip
1. Clean the board
Thoroughly clean all traces of wax, dirt and grit from the surfboard. DO NOT USE oil based cleaning products. We recommend acetone, then rinse with hot water.
2. Position and mark
Positioning your tail pad is probably your most important decision when it comes to board performance. It is essential it is positioned just in front of the leash plug, and ideally the base of the kick tail should be placed directly above the end of your back fin.
3. Apply the grip
Begin by lining up and marking the correct position for the rear of the kick. Peel off the backing sticker of the centre piece. Starting at the kick end, centre this piece and align it with your stringer as you work it forward and stick it down. From this initial piece, position the other pieces to suit the overall tail shape and positioning required. When you are happy with the look and position, firmly apply pressure to all of the grip, particularly the edges and kick area, to make sure everything is firmly down. Wait 24 hours for maximum bond. If there are air bubbles under the grip, insert a needle into the problem area and work them out using pressure.
Note: grips only come unstuck due to poor surface preparation. In such cases, restick the lifting area using contact adhesive.
The Atomic: more edges, more grip, thinner feel underfoot.
FEATURES
Multi-layered square with cross traction pattern: Superior grip, thinner feel underfoot.
Combination circle and linear cut-outs: Enhances toe hold.
30mm super kick (45° to vertical): For aggressive manoeuvres.
10mm arch bar with circular cut-outs: More arch with more edges.
3-piece design: Fits various board shapes.
DIMENSIONS
Front width: 31 cm
Length: 31 cm
Tail width: 14.5 cm
MORE
All of our tail pads feature our ultra lightweight, extra grippy EVA (ethylene-vinyl acetate) foam and are backed with the best gluing process in the business. The result of our development process is incredible individualised traction that will stand the test of time at a price that won't have you mortgaging your next surf trip.
